Prepare Steps and Apply Non-Skid Strips

What happens in this clip

Before applying the non-skid strips, ensure that the wooden steps are thoroughly clean and completely dry. Once the steps are prepared, peel off the backing from each adhesive strip and carefully apply it to the surface of each step. Position the strip centered in the available space on the step and near the front edge, where foot traffic is most common. Press down firmly along the entire length of the strip to ensure good adhesion.

Goal: Affix non-skid strips to each step

What's used

Tools

• Adhesive-Backed Non-Skid Strips
• Wooden Steps

About the full video

This project provides a simple and effective DIY solution to prevent slips and falls on wooden steps, especially those made from pressure-treated lumber, which can become dangerously slippery when wet. The solution involves applying adhesive-backed non-skid strips to each step to provide permanent traction.

Step 3 of 5: Install Anti-Slip Tread Strips

Cut the anti-slip tread strips to the desired length to fit each stair tread. Ensure the stair treads are clean and completely dry. Peel the backing off the adhesive side of the strip and carefully position it on the stair tread, starting from the front edge and pressing firmly towards the back. Use a roller or a hard-edged tool to ensure maximum adhesion and to eliminate any air bubbles. Repeat for all stair treads.

Open this step in the guide

Every video in How to Make Concrete Basement Stairs Non-Slip

1. Step 1: Prepare the Concrete Stairs

   • 1:13–1:37 Prepare the Surface
   • 0:28–1:00 Prepare Rough Concrete Steps for Resurfacing
   • 1:13–1:50 Apply Cleaner to Stairs

2. Step 2: Apply Anti-Slip Coating

   • 2:27–3:10 Apply Paint to Stairs
   • 0:46–0:59 Spray Clear Anti-Slip Coating
   • 0:51–4:06 Apply Adhesive-Backed Anti-Slip Products

3. Step 3: Install Anti-Slip Tread Strips

   • 0:02–0:06 Apply Anti-Slip Strip
   • 0:20–0:45 Peel and Adhere Strip
   • 1:12–1:19 Prepare Steps and Apply Non-Skid Strips (this video)

4. Step 4: Apply Textured Paint

   • 2:27–3:10 Apply Paint to Stairs
   • 10:24–11:30 Final Paint and Allow to Dry
   • 0:20–0:31 Painting the Staircase

5. Step 5: Cure and Inspect

   • 1:23–1:32 Allow Coating to Dry and Enjoy the Renewed Surface
   • 1:23–1:28 Allow Coating to Dry
   • 1:49–2:10 Allow Coating to Cure and Verify Non-Slip Property