Mark and Drill Wall Holes

What happens in this clip

With the gate temporarily held in place, use a pencil to mark the exact position of the four wall cups on the wall or door frame. Also, mark the center point within each wall cup where the screw will go. After marking, remove the gate from the opening. Then, use a drill to carefully punch holes at each of the marked screw points.

Goal: Create pilot holes for wall anchors and screws.

What's used

Tools

• Cumbor Baby Gate Cumbor
• Drill Bit
• Drill
• Pencil

About the full video

This DIY project provides step-by-step instructions for securely hardware mounting a Cumbor baby gate, which is highly recommended for safety, especially when installing the gate at the top of stairs. The process includes unpacking components, measuring and adding extensions if needed, marking and drilling holes, installing wall anchors and cups, tightening the gate, and finally, testing its functionality.

Step 3 of 6: Drill Pilot Holes

Select a drill bit that is slightly smaller than the diameter of the screws provided with the baby gate. For each marked screw position, drill a pilot hole into the solid wood. The depth of the pilot hole should be sufficient to accommodate the length of the screw, but not so deep that it compromises the integrity of the wall.

Open this step in the guide

Every video in How to Install a Hardware-Mounted Baby Gate at the Top of Stairs

1. Step 1: Identify Mounting Surfaces

   • 0:24–0:31 Install Lower Wall Mounts (First Side)
   • 0:13–0:18 Prepare Mounting Boards
   • 0:23–0:32 Install Wall-Mount Baby Gate

2. Step 2: Mark Bracket Positions

   • 2:59–3:10 Mark, Drill, and Secure Top Mounting Bracket (Side 1)
   • 1:21–1:35 Position Gate and Mark Wall
   • 1:26–1:45 Position Gate and Mark Wall

3. Step 3: Drill Pilot Holes

   • 1:05–1:12 Mark and Drill Wall Holes (this video)
   • 1:50–2:02 Mark and Drill Bottom Pilot Holes (Side 1)
   • 1:18–1:48 Drill Pilot Holes and Insert Anchors

4. Step 4: Attach Mounting Brackets

   • 1:43–1:50 Secure Wall Brackets
   • 3:44–4:19 Secure Mounting Brackets (Side 2)
   • 3:14–3:37 Mount the Bracket to the Wall

5. Step 5: Attach Gate to Brackets

   • 3:44–4:19 Secure Mounting Brackets (Side 2)
   • 1:48–1:55 Mount the Gate into Brackets
   • 3:37–4:15 Install the Safety Gate

6. Step 6: Adjust and Test Gate Functionality

   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:30–2:19 Final Assembly and Testing
   • 3:49–4:22 Verify Security and Functionality