Glue and Install the First Baluster

What happens in this clip

After the baluster has been accurately trimmed to size (the cutting process is not shown in this segment), apply a generous amount of wood glue, specifically Titebond Premium Wood Glue, around the removable locator pin at the bottom of the baluster. Carefully insert the glued pin into the prepared, recessed hole on the stair tread. To attach the top of the baluster, gently lift the handrail upwards just enough to create space. Then, guide the tapered top end of the baluster into its corresponding hole in the handrail. Once both the bottom pin and the top are seated, twist the baluster slightly to ensure the glue spreads evenly. Immediately wipe away any excess glue that oozes out with a damp rag for a clean finish. The goal is for the baluster to fit snugly and securely without the need for additional caulk.

Goal: Securely install a baluster into the prepared tread and handrail holes

What's used

Tools

• Handrail
• Removable Pin
• Trimmed Baluster

Materials

• Titebond Premium Wood Glue Titebond
• Elmer's Wood Glue
• Wet Rag

About the full video

This project details the process of replacing balusters on a staircase without removing the handrail. It involves preparing the existing holes on the stair treads, accurately measuring and trimming new tapered balusters with removable locator pins, and then gluing them into place. The project emphasizes precise fitting to achieve a clean, professional finish.

Step 4 of 5: Install New Baluster

Apply wood glue to the tenons or ends of the new baluster that will connect to the handrail and tread. Position the baluster in place. If it uses dowels, insert them into the corresponding holes. If it screws in, pre-drill pilot holes and drive screws. For mortised connections, ensure a snug fit and secure with glue. Ensure the baluster is plumb and securely fastened.

Open this step in the guide

Other videos for this step

• Complete Baluster Installation
• Cut and Install Balusters with Glue and Nails