Complete Baluster Installation

What happens in this clip

Continue the installation process for all remaining balusters, following the same steps. Each baluster should be measured and trimmed individually to ensure a perfect fit between the stair tread and the handrail. Apply Titebond Premium Wood Glue to the removable locator pin at the base of each baluster. Insert the pin into its corresponding prepared hole on the stair tread. Lift the handrail slightly to insert the tapered top of the baluster into the handrail's hole, then twist gently to set the glue. Immediately clean any excess glue with a wet rag to maintain a neat appearance. Once all balusters are installed, the staircase will have a refreshed and stable railing system.

Goal: Install all new balusters on the staircase

What's used

Tools

• Handrail
• New Balusters
• Removable Pins

Materials

• Titebond Premium Wood Glue Titebond
• Elmer's Wood Glue
• Wet Rags

About the full video

This project details the process of replacing balusters on a staircase without removing the handrail. It involves preparing the existing holes on the stair treads, accurately measuring and trimming new tapered balusters with removable locator pins, and then gluing them into place. The project emphasizes precise fitting to achieve a clean, professional finish.

Step 4 of 5: Install New Baluster

Apply wood glue to the tenons or ends of the new baluster that will connect to the handrail and tread. Position the baluster in place. If it uses dowels, insert them into the corresponding holes. If it screws in, pre-drill pilot holes and drive screws. For mortised connections, ensure a snug fit and secure with glue. Ensure the baluster is plumb and securely fastened.

Open this step in the guide

Other videos for this step

• Cut and Install Balusters with Glue and Nails
• Glue and Install the First Baluster