Drill Holes and Install Wall Cups

What happens in this clip

Using a drill, carefully create a pilot hole at each of the four pencil marks you made on the wall. These pilot holes will guide the screws and prevent the wood from splitting. Once the pilot holes are drilled, align each wall cup over its corresponding hole and use a screwdriver to securely screw the wall cups into the wall using the provided 1-inch wall mount screws. Ensure the wall cups are firmly attached and stable.

Goal: Securely attach the wall cups to the wall

What's used

Tools

• 1-inch Wall Mount Screws
• Drill
• Screwdriver
• Wall Cups

About the full video

This DIY project provides a detailed, step-by-step guide on how to install a plastic expandable gate. It covers measuring the doorway, accurately marking and drilling pilot holes for wall cups, securely screwing the wall cups into place, and finally installing and locking the gate for a safe and secure fit.

Step 2 of 6: Install Wall-Side Mounts

Using a drill, create pilot holes at the marks you made on the wall. The size of the pilot hole should be slightly smaller than the screws you will be using. If not drilling into a stud, insert appropriate wall anchors. Then, screw the wall-side mounting hardware securely into place, ensuring it is plumb and stable.

Open this step in the guide

Every video in How to Install a Baby Gate on Stairs with a Banister on One Side and a Wall on the Other

1. Step 1: Determine Gate Placement

   • 1:05–1:12 Mark and Drill Wall Holes
   • 2:14–3:30 Mount Gate Assembly Brackets
   • 0:08–0:09 Determine the position of the upper hinge

2. Step 2: Install Wall-Side Mounts

   • 0:54–1:08 Drill Holes and Install Wall Cups (this video)
   • 0:00–0:50 Install Wall Brackets Securely

3. Step 3: Attach Banister Mounting Hardware

   • 0:27–0:33 Attach Clamps to the Banister Post
   • 0:14–0:26 Understand the No-Holes Banister Installation Kit
   • 0:43–1:10 Install Baby Gate and Verify Compatibility

4. Step 4: Mount the Gate

   • 11:15–11:22 Mount and Adjust the Gate
   • 2:15–2:40 Install Spindles and Final Gate Mounting
   • 3:44–4:19 Secure Mounting Brackets (Side 2)

5. Step 5: Adjust and Test Latches

   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:11–1:59 Verify Gate Functionality and Safety
   • 3:49–4:22 Verify Security and Functionality

6. Step 6: Final Safety Check

   • 3:49–4:22 Verify Security and Functionality
   • 3:27–3:34 Final Review and Finishing Touches
   • 1:11–1:59 Verify Gate Functionality and Safety