Determine the position of the upper hinge

What happens in this clip

Temporarily position the baby gate in the opening. Place the upper hinge component against the desired mounting surface (e.g., a wall or banister post) where the gate will swing. Ensure it is level and at the appropriate height as per the gate's instructions.

Goal: Locate and prepare for the upper hinge installation.

What's used

Tools

• Baby Gate Babelio
• Upper Hinge Babelio

About the full video

This project provides step-by-step instructions on how to install a Babelio baby gate. The process covers confirming all parts, measuring the opening, positioning and marking hinge and latch locations, drilling pilot holes according to wall material (wood, concrete/brick, or drywall), installing hinges and latches, and finally adjusting the gate's width for a secure fit and proper function.

Step 1 of 6: Determine Gate Placement

Before drilling, decide on the precise mounting points. For the wall side, hold the gate at the desired height and mark the screw hole locations. For the banister side, use the banister mounting kit's template or the gate's hardware as a guide to mark the attachment points, taking into account any angled surfaces or required spacing for the mounting kit.

Open this step in the guide

Every video in How to Install a Baby Gate on Stairs with a Banister on One Side and a Wall on the Other

1. Step 1: Determine Gate Placement

   • 1:05–1:12 Mark and Drill Wall Holes
   • 2:14–3:30 Mount Gate Assembly Brackets
   • 0:08–0:09 Determine the position of the upper hinge (this video)

2. Step 2: Install Wall-Side Mounts

   • 0:54–1:08 Drill Holes and Install Wall Cups
   • 0:00–0:50 Install Wall Brackets Securely

3. Step 3: Attach Banister Mounting Hardware

   • 0:27–0:33 Attach Clamps to the Banister Post
   • 0:14–0:26 Understand the No-Holes Banister Installation Kit
   • 0:43–1:10 Install Baby Gate and Verify Compatibility

4. Step 4: Mount the Gate

   • 11:15–11:22 Mount and Adjust the Gate
   • 2:15–2:40 Install Spindles and Final Gate Mounting
   • 3:44–4:19 Secure Mounting Brackets (Side 2)

5. Step 5: Adjust and Test Latches

   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:11–1:59 Verify Gate Functionality and Safety
   • 3:49–4:22 Verify Security and Functionality

6. Step 6: Final Safety Check

   • 3:49–4:22 Verify Security and Functionality
   • 3:27–3:34 Final Review and Finishing Touches
   • 1:11–1:59 Verify Gate Functionality and Safety