Step Above MORryde RV Motion Lights Upgrade (Ep. 1)
Video by Austin Alley Adventures · 2 moments used in Oak Valley Designs's DIY guides · 2:39 long

Moments in this video
- 1:40–1:47 Insert AAA Batteries into Lights
From How to Install Battery-Powered Motion Stair Lights Without Wiring, Step 4: Install Batteries
For each motion-activated light, open the battery compartment. Insert four AAA batteries, ensuring correct polarity as indicated inside the compartment. Close the battery compartment securely.
- 2:05–2:16 Mount Motion-Activated Lights
From How to Install Battery-Powered Motion Stair Lights Without Wiring, Step 3: Mount Light Fixtures
Once the magnetic strips are firmly attached to the brackets, simply slide each motion-activated light onto the magnetic strip. The magnets will hold the lights securely in place. Ensure the light is properly aligned and stable. With this step, the installation is complete. The lights will now be ready to function, illuminating the steps when motion is detected, particularly useful in low-light conditions.
The guide that use this video
Transcript
0:04 hello everyone I'm Dan with Austin alley Adventures today we're going to do a moride step above upgrade for under 30 bucks hang tight we'll be right back [Music] So today we're going to install motion activated lights from moride on our Step Above steps this is what comes in the kit from moride two motion activated lights two magnetic strips two aluminum hanging
0:53 brackets four screws four adhesive patches as an alternative way to adhere the bra brackets the first thing you're going to need to do is figure out where you're going to space the lights on your step I've decided I'm going to put mine under the top step and under the bottom step I can't put it in the middle because some of the moride step above steps come with a handle now fold your steps up into the rig so you have access underneath these lights can be used on a variety of other RV steps as well now taking the aluminum bracket and a couple of screws Center the bracket on the step I'm just going to eyeball it as long as you're close you'll be
1:39 fine now we're going to take both lights and install four AAA batteries in each light take the two magnetic strips and peel the paper off the adhesive strips attach them to the brackets this double-sided tape is going to hold the magnet to the bracket you might want to press down with some pressure to make sure the adhesive seals really good to the bracket just slide the light onto the magnet and that's it you're done it takes less than 10 minutes when it gets dark later I'll show you what they look like so for under 30 bucks you can give yourself and your family a little piece of Mind of going up and down the steps in the dark I will leave a link in the
2:25 description on where you can purchase these lights and if you find something you like on the video give us a thumbs up and subscribe we' greatly appreciate it thanks for watching everyone
Automatically transcribed from the source video.
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

