Post Anchor Installation on Concrete ASMR
Video by Andrew Thron Improvements · 1 moment used in Oak Valley Designs's DIY guides · 0:10 long

Moments in this video
- 0:00–0:02 Drill Anchor Hole in Concrete
From How to Install a Handrail on Outdoor Concrete Steps, Step 2: Drill Pilot Holes for Post Anchors
Begin by marking the precise location for your post on the concrete surface. This can be done using a chalk line or marker. Then, using a rotary hammer drill equipped with a masonry drill bit of the appropriate diameter (matching your anchor bolt, typically 5/8 inch), drill a hole into the concrete. Ensure the hole is deep enough to fully accommodate the anchor bolt as specified by the manufacturer. The video shows blue chalk lines indicating the post's intended footprint.
The guide that use this video
Transcript
0:04 Put there. Usually it's going to be a little vertical support. Okay.
Automatically transcribed from the source video.
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

