How to wire LUTRON Motion Sensor light switch (single pole) occupancy sensing
Video by HOW2DOit? · 1 moment used in Oak Valley Designs's DIY guides · 1:00 long

Moments in this video
- 0:52–0:58 Connect the Ground Wire
From How to Install a Motion-Sensor Light Switch in a Stairway, Step 5: Connect Ground Wire
The motion sensor switch will have a bare copper or green insulated ground wire. Connect this ground wire to the existing ground wire in the wall box (if present, usually bare copper or green) or to a grounding screw on the metal electrical box itself. Ensure the connection is tight and secure, typically by looping the wire around a screw and tightening it, or by using a wire nut if joining with other ground wires.
The guide that use this video
Transcript
0:02 switch a regular outlet to a motion sensor switch the top was connecting both of these red wires make sure they stay together and don't separate them and the other one was connecting to the yellow wire wire on the top goes to the hot line that has power the other black line goes to a load line which is usually orange or yellow this is the hotline it has power this is the top black line This is the load line now is connected to the other black line I saw the two white wires Capp together in yellow when I get close there's no power but when I get to the power one it has power in your box if you have neutral you got to remove the green sleeve remove it under the green sleeve is this white neutral line that connects to my
0:49 neutral wires which is also white finally this metal fin this metal wire goes behind the screw that screws to the Box taada
Automatically transcribed from the source video.
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

