How To Paint Your Front Concrete Stairs Like New Again! Front Entry Steps Transformation DIY!

Moments in this video

1. 2:15–4:46 Surface Preparation and Grinding From Anti-Slip Steps, Step 2: Prepare the Surface

   Using a chisel and a hammer, carefully chip away any raised or loose concrete on the steps, especially along the edges. After removing the larger pieces, use a brush to sweep debris from crevices and corners. The most crucial step is to grind the concrete surface. Use an angle grinder equipped with a 4.5-inch grinder wheel or flap disc to remove all remaining loose and peeling paint, as well as to feather any lifting edges. For safety, wear a particulate respirator, safety glasses, and ideally a face shield. The grinder shield was removed to access tight corners, but this should be done with extreme caution. After grinding, sweep up all debris thoroughly with a broom and use a shop vac to remove fine dust from all edges and hard-to-reach areas.

2. 4:46–6:13 Patch Concrete Imperfections From Anti-Slip Steps, Step 2: Prepare the Surface

   After the surface is clean and smooth, inspect for any remaining craters, dimples, or chipped areas. Use a ready-mix concrete patch, like Sika Pro Select Ready-Mix Concrete Patch. This product is pre-mixed and ready to use, making the application process convenient. Apply the patch directly onto the imperfections using a trowel or putty knife, ensuring to feather the edges for a seamless repair. Work quickly, as the patch can harden faster in hot weather (the creator noted working in over 75-degree Fahrenheit weather). Also, apply the patch to any chipped edges of the steps, smoothing it out for an even finish. Properly feathered edges will reduce the need for further sanding or grinding.

The guide that use this video

• Anti-Slip Steps