powered by

How To Install An Attic Ladder - DIY At Bunnings

Video by Bunnings Warehouse · 3 moments used in Oak Valley Designs's DIY guides · 7:34 long

Moments in this video

  1. 0:53–2:08 Determine and Mark the Ceiling Opening From Attic Ladder Installation, Step 1: Measure and Mark Ceiling Opening

    Begin by measuring the precise width and length of your attic ladder unit. In the hallway or designated installation area, find and mark the center of the ceiling. From this center line, measure out half the width of the attic ladder to mark where one edge of the opening will be. Repeat this process on the opposite end of the hallway to establish the second parallel line. Use a level and pencil to connect these marks, creating a clean, straight line. Repeat for the other side to fully define the width of the new opening. To determine the length, locate an existing joist in the ceiling and use it as a reference point. Measure back from this joist to mark one end of the opening. Draw this line, then measure the full length of the attic ladder from this first end line to mark the opposing end. Again, use a level to ensure all lines are straight and the rectangle is square.

  2. 2:09–2:22 Cut the Plasterboard From Attic Ladder Installation, Step 2: Cut Ceiling Opening

    Once the lines are accurately marked on the ceiling, use a plasterboard saw to carefully cut along these marked lines. It is crucial to wear appropriate safety gear during this step, including safety goggles to protect your eyes from falling debris and a dust mask to prevent inhaling plasterboard particles. Before making any cuts, double-check that no electrical cables or plumbing pipes are present within the cutting path. Proceed slowly and deliberately to ensure clean and precise cuts.

  3. 5:36–6:05 Pack and Secure the Other Side From Attic Ladder Installation, Step 4: Position and Secure Attic Ladder

    With the first side of the attic ladder frame securely fastened, shift your attention to the opposite side. Take several peckers (thin wooden wedges) and snap them to a size that roughly matches the gap between the ladder frame and the noggin. Carefully insert these peckers along the entire length of the unsecured side of the frame. The goal is to create an extremely tight fit; if the fit is too loose, driving the screws will cause the frame to pull out of square, leading to an uneven and potentially unsafe installation. Once the side is tightly packed and the frame is held firmly against the noggin, use your drill to pre-drill pilot holes and then drive three 75mm wood screws through the attic ladder frame into the noggin, mimicking the pattern used on the first side (one at each end, one in the middle).

The guide that use this video

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

How To Install An Attic Ladder - DIY At Bunnings — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.