How to fix your handrail to a newel post using the StairBox QuickFix Kit.
Video by StairBox · 2 moments used in Oak Valley Designs's DIY guides · 1:20 long

Moments in this video
- 0:12–0:29 Mark Handrail and Newel Post for Installation
From How to Install a Handrail Return at the End of a Rail, Step 1: Mark Handrail Return Position
Ensure your newel posts are securely fixed in place. Determine the desired height for your handrail, keeping in mind that the minimum height required by building regulations is 900mm (approximately 35.4 inches). Next, use a pencil to mark a point approximately 30mm (about 1.2 inches) lower than the intended top of your handrail. This mark should be centered horizontally on the newel post. Create a corresponding mark centrally on the end face of the handrail, ensuring it aligns with the mark on the newel post.
- 0:54–1:00 Connect Handrail to Newel Post
From How to Install a Handrail Return at the End of a Rail, Step 5: Mount Handrail Assembly to Wall/Newel Post
Before making the final connection, apply a suitable wood glue to the joint where the end of the handrail will meet the newel post. This provides a stronger, more stable, and permanent bond. Carefully align the handrail's screw with the hook plate on the newel post and firmly slot the handrail into place. You should feel it 'click' as the screw engages and locks into the hook plate. Once connected, ensure the handrail is flush and securely attached.
The guide that use this video
Transcript
0:09 here we are going to show you how to fit a handrail to the newal post using the stairbox rail fix system once your news are securely fixed in place choose the height of your handrail the minimum height for building regulations is 900 mm next Mark a point an inch or so lower than the top of your handrail centrally on the post you will need to put a corresponding Mark centrally on the end of the handrail you can now drill a 30 mm diameter hole just 6 mm deep ready to accept the fixing plates using the three screws provided fix the hook plate making sure it's nice and secure you will want to leave the Locking clip off while checking the hand rail is a snug fit or if you are temporarily fitting your hand [Music] rail next pre-drill your hand rail and drive the screw in through the washer apply glue to the Joint before slotting
0:55 the hand rail into the hook plate you should feel this click into place all that's left is to finish the staircase if you have any questions please feel free to call us on 01782 83255 or send us an email to hello stox.com and one of our advisers will be more than happy to help
Automatically transcribed from the source video.
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

