HOW TO FIT CARPET ON STAIRS, UNDERLAY AND GRIPPERS #staircarpet #carpetfitting #homeimprovement

Moments in this video

1. 0:29–1:33 Prepare Stairs and Measure Grippers From How to Install Carpet Stair Treads on Curved Stairs, Step 1: Measure Tread Dimensions

   Before starting, remove any old carpet or flooring from the stairs to expose the bare treads. Using a measuring tape, measure the width of the stairs from wall to wall. It's crucial to check multiple stairs as their widths may vary. For the carpet grippers, cut them about 5mm (approximately 1/4 inch) shorter than the stair width on each side. This small gap allows for the carpet to be neatly tucked in later.

2. 6:25–8:58 Measure and Cut Carpet Sections From How to Install Carpet Treads on Metal Spiral Stairs, Step 2: Measure and Cut Carpet Treads

   For the actual carpet, carefully measure the width of the stairs from wall to wall. Since stairs may not be perfectly straight (especially in older homes in the UK), measure at different points (e.g., at the back and front of the step) and use the biggest measurement. Then, add 3-4mm (approximately 1/8 inch) to this largest width. This extra allowance ensures the carpet can be properly tucked down the sides. For the length, measure the depth of the tread and the height of the riser, similar to the underlay. To make handling easier, cut the carpet into manageable sections (e.g., 1-meter sections) from the main roll before making the final cuts for each individual step. Ensure a straight edge is maintained for all cuts.

Guides that use this video

• How to Install Carpet Stair Treads on Curved Stairs
• How to Install Carpet Treads on Metal Spiral Stairs