How To Caulk with a Caulking Gun
Video by Lowe's Home Improvement · 1 moment used in Oak Valley Designs's DIY guides · 1:36 long

Moments in this video
- 0:51–1:07 Test and Apply Caulk
From How to Caulk Gaps Along Stair Skirt Boards, Step 4: Apply the Caulk
With the caulk gun loaded, gently squeeze the trigger until the caulk begins to dispense smoothly from the tip. Before applying to your actual project, test your caulk bead on a piece of scrap paper or a rag to ensure it's the right size and consistency. To apply the caulk, position the gun at an angle against the joint you wish to seal. Drag the gun backward along the joint while maintaining steady pressure on the trigger. Work in small, manageable sections to keep your caulk bead as even and regular as possible.
The guide that use this video
Transcript
0:01 [Music] cocking is a simple and effective way to seal gaps around doors windows counters bathtubs sinks and more before you start remove old caulk with utility knife poor caulk removal tool wipe down the area with rubbing alcohol or a household cleaner and let it dry if you are caulking indoors you can add painters tape to help create clean caulk lines caulk comes in tubes or caulk gun canisters to load a caulk gun cut the tip of the canister at an angle with a utility knife the larger the hole you cut in the canister the bigger the bead will be so start smaller and enlarge the opening if needed many guns include an attached cutter in the handle of the caulk gun after cutting puncture the interior foil with the attached pin or with a nail load the canister in the gun and press
0:48 the rod into the back of the canister until you feel it engage squeeze the trigger until the caulk is ready to dispense test your caulk bead on a piece of paper or a rag to make sure it is the right size apply the caulk by dragging the gun backwards across the joint and pulling the trigger work in small sections and try to keep your bead even and regular finish your bead with a finishing tool to push it into the corners and create a smooth surface you can also use a spoon or a wet gloved finger to smooth the caulk remove your tape when the caulk is tacky but not yet dry for the cleanest lines store excess caulk in the canister by sealing the end with a galvanized nail or wire nut
Automatically transcribed from the source video.
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

