Fix Squeaky Floors with the Squeeeeek No More Floor Repair Kit
Video by Home Repair Tutor · 1 moment used in Oak Valley Designs's DIY guides · 3:47 long

Moments in this video
- 2:48–3:49 Drive and Snap Off the Screw
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors, Step 4: Install Repair Screws
Once the screw and depth control tool are assembled on the drill, align the depth control tool directly over the previously located floor joist. Push the tool firmly down into the carpet to expose the screw tip. Use the drill to drive the screw down through the carpet, subfloor, and into the joist. The depth control tool will automatically stop the screw at the correct depth, preventing it from being over-driven. After the screw is fully seated, a small portion of its head will be slightly visible above the carpet surface. Now, remove the drill. Take the depth control and alignment tool and slide its specialized slot over the exposed screw head. Rock the tool back and forth firmly to engage the scored section of the screw, causing the head to snap off cleanly. The remaining part of the screw will be hidden approximately one inch below the carpet's surface, making the fix invisible and undetectable underfoot. This process effectively pulls the subfloor tightly against the joist, eliminating the squeak.
The guide that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

