powered by

Amir Motion Sensor Light

Video by Land to House LLC · 1 moment used in Oak Valley Designs's DIY guides · 2:42 long

Moments in this video

  1. 1:35–1:50 Test Light Functionality From How to Install Battery-Powered Motion Stair Lights Without Wiring, Step 5: Test Functionality

    To test the installed motion sensor light, close the pantry or cabinet door to create a dark environment. The sensor has a 10-foot range and is quite sensitive. Then, open the door as you normally would. Observe how quickly the light detects the motion and illuminates the interior, providing immediate visibility.

The guide that use this video

Transcript

0:01 a mirror send me a 3-pack of their wireless motion sensor lights so let's open the box and take a look all right let's open up the box real quick so inside is going to be three separate small boxes and inside of each of those you will find a light that's wrapped in a bag each light has 10 LEDs and a motion sensor and on the side is this compartment for four triple-a batteries [Music] as you can see because it is light in here it's not going to come on with movement so it has to be in a fairly dark room before it will turn on so

0:47 we'll show that in just a minute on the back of the light you can see this 3m magnetic strip and that is to be attached to a surface and then this will hang from that strip so let's go over here to our pantry and we'll get this installed I'm going to remove the sticky tape here on the back and then get this set into the top of the doorframe give it a little push there and now I can peel this light off of that magnetic strip to change the batteries when it goes dead and keep it up here for normal use so let's close the door real quick and see

1:33 how well this works the sensor has a 10-foot range and it's quite sensitive and I open the door you can see it comes on really quick there the light is very simple and easy to install and definitely gives enough light for a cabinet or closet or pantry and our case so if you'd like to check these out I have a link in the description down below and I'm going to be giving away two of these so if you would write a comment in the comment section below and I will pick one in the winter to receive the two lights that are left in here thank you for watching I will see you in the next video bye

Automatically transcribed from the source video.

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Amir Motion Sensor Light — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.