Secure Carpet with Staples

What happens in this clip

Once the carpet patch is correctly positioned, use a power stapler to begin securing it. Drive staples along the back edge of the carpet where the tread meets the riser, ensuring they penetrate through the carpet, padding, and into the wooden subfloor. Space staples approximately every 2-3 inches for a strong hold. Also, secure the carpet along the side edges of the tread if it abuts a wall or banister. This initial stapling prevents the carpet from shifting during the stretching process.

Goal: The initial securing of the carpet patch involves using a power stapler to firmly attach the carpet to the wooden subfloor, particularly along the back and side edges of the tread.

What's used

Tools

• Power Stapler

Materials

• Staples

About the full video

This video provides a step-by-step demonstration of how to repair a damaged carpeted stair step. The process involves removing the old, damaged materials, installing new carpet padding, laying down a new piece of matching carpet, securing it with staples, stretching it taut with a knee kicker, and finally tucking and finishing the edges for a seamless repair.

Step 5 of 7: Reinforce Loose Carpet Edges (Optional)

For any carpet edges that still feel slightly insecure or are prone to lifting, you can use a heavy-duty staple gun or small carpet tacks. Place them discreetly along the very edge of the tread, underneath where the carpet overlaps the nosing, or along the vertical riser if applicable. Ensure they are driven in fully and do not protrude.

Open this step in the guide

Every video in How to Fix Popping Noises from Adhesive Carpet Treads on Wood Stairs

1. Step 1: Inspect Carpet Tread Noise

   • 0:00–0:17 Identify Squeak Location
   • 2:21–3:48 Diagnose Creaking Causes

2. Step 2: Examine Carpet Tread Adhesion

   • 0:00–0:04 Inspect Damaged Carpet Edge
   • 0:06–0:17 Inspect Loose Stair Nosing
   • 0:36–0:40 Apply Adhesive to Secure Carpet

3. Step 3: Clean Carpet Tread Underside and Stair Surface

   • 0:09–0:45 Prepare and Clean Stair Treads
   • 0:07–0:17 Apply Adhesive to Carpet and Subfloor
   • 0:00–0:05 Prepare the Loose Carpet Section

4. Step 4: Apply New Adhesive

   • 0:07–0:17 Apply Adhesive to Carpet and Subfloor
   • 0:04–0:08 Apply Spray Adhesive
   • 0:04–0:08 Apply Carpet Adhesive

5. Step 5: Reinforce Loose Carpet Edges (Optional)

   • 0:29–0:34 Secure Carpet Edge with Staples
   • 0:08–0:11 Secure Carpet at Bullnose with Stapler
   • 0:11–0:14 Secure Carpet with Staples (this video)

6. Step 6: Address Sub-Surface Creaks

   • 3:29–3:39 Eliminate Squeaks from Treads
   • 0:14–0:34 Fix Squeaks from Underneath with Shims
   • 1:24–2:44 Fix Squeaks on Carpeted Stairs

7. Step 7: Test Repaired Treads

   • 11:15–11:37 Final Inspection
   • 0:07–0:10 Test Stair Stability
   • 4:28–5:00 Test the Repaired Stairs