How to Retrofit Under Cabinet LED Strip Lights #shorts
Video by Charlie DIYte (CharlieDIYte) · 1 moment used in Oak Valley Designs's DIY guides · 2:37 long

Moments in this video
- 0:52–1:41 Prepare and Connect LED Strips
From How to Cut and Join LED Strip Lights Around Stair Corners, Step 3: Prepare LED Strip Ends for Connection
The LED strip (e.g., 14.4W, 3000K, 24V) is cut to the required length. The factory-sealed connectors often provided with LED strips are problematic in tight spaces and can prevent the LEDs at the very end from being lit correctly. To overcome this, the existing connectors are removed. The wires from the LED strip's 'tail' are then stripped and carefully slotted into specific 2-pin 5mm LED light strip connectors (e.g., Masterwon brand) bought online. These solderless connectors offer a tighter angle and a more discreet connection than soldering.
The guide that use this video
Transcript
0:01 After installing the new kitchen and lighting, we realized we had shadows under the units. So, I decided to retrofit mains-powered LEDs, and I'm going to show you today how I did it. My kitchen fitter made the units with removable base outside, which gave me the idea of recessing an LED strip into the base. So, I cut the base piece in two with my circular saw. My electrician then channeled some cabling up from a back box I installed next to a plug socket into the cupboard above via some holes I drilled. The idea being the under-cabinet lights will be controlled by a switch fuse. But, I just needed to cut some holes in the plasterboard between the two units so we could thread the cable into the second cupboard, missing the central stud that I found using my super strong magnet. I then drilled a hole in the aluminum track I bought and cut a channel in it for the wiring with my Dremel. I could then
0:47 drill the channel and fix it in position with screws. I guess I could have glued it in place or just used double-sided tape. 5-mm wide LED strips come with connectors at each end, but I'm not a big fan of these. I don't like this end, the sealed end that comes with the strip cuz it's too hard. It's really hard to get it into tight spaces like, you know, if I put it into the strip in a minute, this is the diffuser bit, you've got all of that that's not going to be lit in the corner. So, I came up with a new plan. So, I trimmed the LED strip to the length I wanted it, used part of that tail that came with it, stripped and tidied up the wires, and then slotted them into these brilliant little connectors that I bought on Amazon. It's fiddly, but the other option is soldering the electrics to the LED strip, and I didn't fancy trying to do
1:33 that here or for that matter here. So, this can be turned a much tighter angle with the light with you still having plenty of LED in the strip. And now the easy bit, peeling off the self-adhesive backing to stick the LED strip into the channel. I had a cheeky bit of routing to do to the rear base panel before fitting it in place. And the routed channel takes the electrics from the cupboard to the LED strip, and it's fully maintainable by simply removing the panel. The cable from the LED strip was then connected into this driver, which sits discreetly in the cupboard. I was nearly finished. I just had to press in place the diffuser, which basically turns the pinprick of light you get with a LED strip into a constant beam. The side
2:19 panel could then be reattached and screwed in place. So, I hope that's given you some ideas if you need to add some extra lighting to your kitchen. Be great to have you subscribe, and don't forget to click the bell notification icon so you get notified of all my future updates. Thanks for watching, and I'll see you soon.
Automatically transcribed from the source video.
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

