powered by

How To Layout, Cut And Install Wainscoting On Stairs #wainscoting #miter #bevel

Video by Sawset Tools · 1 moment used in Oak Valley Designs's DIY guides · 5:53 long

Moments in this video

  1. 0:32–2:11 Map Out Wainscoting Layout From Board and Batten Wainscoting Installation, Step 1: Measure and Mark Wainscoting Height

    Before cutting any materials, you need to map out the entire wainscoting layout on the wall. Begin by marking where the top of your chair rail will sit, in this example, 32 inches (81.28 cm) off the floor. Use a level to draw a straight, horizontal line at this height. Next, draw a level vertical line that starts from the intersecting point of the existing baseboard. The presenter mentions that baseboards have already been installed using similar techniques. For the third step, use a framing square to draw another line extending from the baseboard intersecting point. Finally, square up on the line you just created with the framing square and extend it so it crosses over to the previously marked chair rail intersection point. To complete the layout, extend the chair rail line all the way down the stairwell. This is done by measuring the vertical distance from the top of the existing baseboard to the top of the marked chair rail line. Transfer this measurement to the base of the stairs, marking a corresponding point. Connect these points with a chalk line to establish the final, angled top line for the wainscoting panels along the stairs.

The guide that use this video

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

How To Layout, Cut And Install Wainscoting On Stairs #wainscoting #miter #bevel — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.